Equinox 600/800
Handle upgrade
 

g)

  

NOX-1

  • Glides through the water like you have never experienced.

  • Light, strong and rigid

  • Only .40 pounds

  • Bolts (for maximum rigidity) directly to your Equinox 600 or 800 with the supplied Stainless screws, with our without the plastic knobs.

  • Included are colored knobs/screws which you might like. Yellow is a 6mm and screws the upper handle and the red is 1/4-20 for the mid shaft. Be sure not to mix up the screws: The finer thread 6mm screws for the upper connection and the 1/4 course thread for the mid section.

  • The lower tear drop shaped rubber washers are larger than the original Minelab. 2 spare washers are supplied incase you wear the original set out in a year or two.

  • You should use your original coil screw and nut but we have included a spare nylon screw and wing nut just incase.

  • Carbon Fiber Mid and Lower shaft

  • A premium roll of 3M black tape is included so you can seal all holes and joints so sand will not enter and freeze up your shafts.

  • The Mid shaft is 3/4" diameter, smaller than the 20mm original

  • The lower shaft is 10mm diameter (just over 3/8")

  • We provide a 3 year warranty if you seal all holes and joints with black electrical tape (supplied) so sand will stay out of the joints.

Included:
All parts as shown in the picture.

In stock, normally shipped within 24 hours
 

Thumb for equinox-package2.jpg (31 KB) Thumb for equinox-package3.jpg (47 KB) Thumb for equinox-red.jpg (33 KB) Thumb for equinox-yellow.jpg (43 KB)

We supply socket head screws and screws with plastic knobs.  It is your choice what to use

 

OWL Engineering
11542 Timken Avenue
Warren, Michigan 48089 - USA
  

    Email: info@owl-engineering.com
Telephone: 1 586 755 5821
Fax: 1 586 755 6179

Made in the USA